Insufficient drying of undercoat primer.
Excessive film thickness of basecoat.
Excessive film thickness of clearcoat.
Soft sensitive under-substrate to thinners.
Use of non-recommended hardener/thinner.
Wrong mixing ratio of hardeners and thinners, not the proper amount of hardener.
Incorrect flash-off times between coats.
Use of expired or not well-stored hardener.
Polishing prematurely according to the drying time of the clear coat.
Not appropriate airflow in spraying booth.
Nor properly completed bake process or interrupted bake process.
Apply the correct film thickness of primer, basecoat and clearcoat.
Dry properly all film layers.
Close hardeners firmly after use to avoid humidity entrapment.
Clean filters and check the air ducts are clean to ensure proper airflow in spraying booths.
Ensure sufficient airflow in a cabin during the baking process and cooling time.
Allow baking and cooling time process to be completed according to specifications.
Apply the correct film thickness of primer, basecoat and clearcoat.
Dry properly all film layers.
Close hardeners firmly after use to avoid humidity entrapment.
Clean filters and check the air ducts are clean to ensure proper airflow in spraying booths.
Ensure sufficient air flow in a cabin during the baking process and cooling time.
Allow baking and cooling time process to be completed according to specifications.
-
Can products be transported in temperatures bellow 0°C?
Most of the products, made by HB BODY SA, are solvent-based, so transportation below 0°C should not be a problem. Products that have problems at low temperatures are products based in water, for the sole reason that water freezes at 0°C
-
Which is the lowest recommended temperature for product application?
The ideal temperature for product application is room temperature and that is 21°C. Product application becomes difficult at temperatures with large deviations from the ideal since the application viscosity increases or decreases (temperature dependent). The lowest recommended product application is about 5-8°C for primers, paints, clear coats and underbody applications. The commonest application temperature for putties is 5°C.
-
What is the shelf-life of a product?
The shelf life of our products is indicated on each Technical Data Sheet (TDS) and outlines the period during which optimal quality and effectiveness are ensured. Proper storage conditions (+5°C - +25°C) (41°F - 77°F), intact packaging, and sealing are essential for maintaining product performance.
Shelf life can vary between product categories and even among products within the same category due to variations in formulation, materials, and ingredients. To guarantee lasting quality, it's crucial to adhere to recommended storage conditions, including avoiding exposure to humidity levels above 80% and direct sunlight.